What are the bending requirements for pipe bending machining?

During the production process, the pipe bending machine effectively pushes the lever forward to fasten the tire, so that it can effectively tighten the tire and clamp the pipe bending machine upward, and then effectively loosen the lever, so that Keep the position where it tightens the tire to a certain extent.During the production process of the cold bending machine, wrinkles are not allowed on the inside, and the ovality of the cross-section should not be greater than 2%D. During the design process, the plane of the cross-section of the product needs to be based on its design requirements. The strength cannot exceed its standard, and the bent parts cannot be damaged during the bending process.

What are the bending requirements for pipe bending machine processing? The first measurement of the pipe bending machine is about 9 mm smaller than the measured size of the rear end of the top mold, so that the pipe bending machine can be positioned in the middle and front part of the top mold. Start bending. If the pipe bending machine starts bending from the rear half of the top mold, it will deform.If the front end of the pipe bending machine is relatively large, it can be slightly lowered during the processing to fasten the tire. To a certain extent, the bending tire can be effectively raised, and the distance can be re-measured to effectively reach the horizontal position of the pipe bending machine. until the requirements are met.The main reason why the pipe bending machine deforms is because the force on the pipe wall of the product is balanced, which can effectively reduce the tendency of instability and deformation to a certain extent. When the inner tire core of the product is correctly used durin